SICK ICR803 Manuale di Avvio Rapido Scaricare il pdf (Pagina 13)

- 13 -

LED Power Level

This selection allows you to adjust LED and aimer brightness. Off is used when no illumination is

needed. Low is used if low illumination is sufficient. High (the default) is the brightest setting. If you

have an aimer delay programmed (see Aimer Delay), the aimer will be at 100% power during the

delay, regardless of the LED Power Level.

Note: If you scan the Off bar code, both the aimer and illumination lights turn off, making it impossible to

scan bar codes in low light. To turn the LED Power Level back on, move to a brightly lit area and scan either

the Low or the High bar code below.

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On bar code, below.

However, if you want to turn just the lights off, scan the Lights Off bar code.

Note: This setting does not affect the aimer light.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

Nessun commento

SICK ICR803 Manuale di Avvio Rapido Pagina 13